During the use of adult dolls, the standardization of the cleaning process directly affects the life of the product. For users of the flat chested sex doll, this type of product that focuses on detail design requires a more professional maintenance plan. This article will combine industry standards and user feedback to analyze common misunderstandings that need to be avoided during cleaning.
1. Minefields in the selection of cleaning agents
According to the national toy safety testing data in 2024, 63% of material damage cases are caused by improper cleaning products. Special attention should be paid to:
Alkaline detergents: Soaps with a pH value of more than 8.5 may destroy the molecular structure of silicone and cause the surface to turn white
Alcoholic solutions: Although 75% medical alcohol can sterilize in short-term contact, long-term use will accelerate the hardening of the material
Bleaching products: Sodium hypochlorite components can easily cause embrittlement of the material, especially for the sutures of flat chested sex dolls
II. Taboos in the operation process
For the special structure of the torso sex doll, the following behaviors may cause irreversible damage:
High-temperature soaking: Hot water above 45°C will cause the silicone to soften and deform. Experiments show that the shrinkage rate of the material increases by 2% after continuous soaking for 10 minutes
High-pressure washing: Direct water gun shooting may destroy the internal filling structure, especially posing a threat to the intelligent temperature control module of the new sex doll
Violent rubbing: Excessive friction in the chest area can easily cause the skin layer to peel off. It is recommended to use a clockwise spiral cleaning method
III. Key points for special structure maintenance
The concave design of the flat chested sex doll requires special attention when cleaning:
Armpit area: It is recommended to use a baby-specific silicone brush with a 1:50 Disinfect with diluted iodine solution
Waistline: negative pressure suction can be used to extract residual liquid in the gap with a syringe
Joint joints: medical-grade silicone grease should be applied after cleaning to prevent abnormal noise due to drying
IV. Precautions for environmental control
Humidity management: After cleaning, it needs to be placed in an environment with a humidity of ≤50%. A humid environment is prone to mold growth
Light protection: Avoid direct sunlight. Ultraviolet rays can cause yellowing of silicone. It is recommended to use an anti-ultraviolet storage cover
Temperature control: The room temperature should be kept above 18°C during winter cleaning. Low temperature may cause the material to crack
V. Reference to industry standards
According to the Technical Specifications for Maintenance of Adult Dolls T/CAQI 238-2024, it is recommended to use:
Neutral cleaning solution: amino acid shower gel dilution with a pH value of 5.5-7.0
Drying time: Natural drying needs to be maintained for more than 24 hours. Avoid using a hair dryer
Disinfection frequency: no more than 3 times a month. Excessive disinfection may damage the surface protective layer of the material
Expert reminder: Users of new sex dolls need to pay special attention to the maintenance guidelines in the product manual. If you find abnormal depression or discoloration in the chest area, stop using it immediately and contact a professional for repair. Regular use of a silicone tester for material analysis can effectively prevent potential problems.
By avoiding the above risk points, the service life of a flat chested sex doll can be significantly extended. It is recommended to establish a cleaning log to record the time, method and product status of each maintenance to facilitate timely detection of abnormal changes. While pursuing cleaning results, following scientific maintenance principles can ensure that the product is always in the best condition.
